Radxa Penta SATA HAT
Radxa ROCK Penta SATA HAT is an addon HAT designed for ROCK Series. It utilizes the high speed PCIe buses on ROCK Series and provides a complete NAS solution based on ROCK Series.
Currently supported Radxa ROCK Series products:
- ROCK 3A
- ROCK 3C
- ROCK 4A / 4B
- ROCK 4A+ / 4B+
- ROCK 4SE
- ROCK 5A
Currently supported Raspberry Pi models:
- Raspberry Pi 5
Feature
- Up to 5x HDD/SSD, support 2.5inch or 3.5inch SSD, up to 100T Storage
- 4x SATA + 1x eSATA with power
- Utilize PCIe buses on ROCK Series and Raspberry Pi
- External standard ATX power supply support for HDDs and SBC itself
- 12V DC power input for 2.5/3.5 HDD power and SBC itself (polarity: center positive)
- Support HDD suspend mode
- Support software RAID 0/1/5
- Optional PWM control fan for HDD heat dispatching
- Optional OLED display for IP/Storage info
If you use large capacity 3.5-inch mechanical hard drives on the Penta SATA HAT, you need to check the hard drive specification to determine the peak current of the hard drive. We recommend using a hard drive with a peak current less than 1.7A.
Package List
-
Radxa ROCK Penta SATA HAT
-
Copper Pillar for fixing
-
Adapter Board
-
IPEX Cable
-
Penta SATA HAT Kit with ROCK 5A support
-
Penta SATA HAT with ROCK 3A / 4A / 4B / 4A+ / 4B+ / 4SE support
-
Penta SATA HAT with ROCK 3C support
40Pin Pinout
Description | Function | Pin# | Pin# | Function | Description |
---|---|---|---|---|---|
1 | 2 | VCC | |||
OLED I2C | I2C_SDA | 3 | 4 | VCC | |
OLED I2C | I2C_SCL | 5 | 6 | GND | |
7 | 8 | ||||
GND | 9 | 10 | |||
top board key | GPIO | 11 | 12 | ||
13 | 14 | GND | |||
15 | 16 | GPIO | reset OLED | ||
17 | 18 | ||||
19 | 20 | GND | |||
21 | 22 | ||||
23 | 24 | ||||
GND | 25 | 26 | |||
27 | 28 | ||||
29 | 30 | GND | |||
31 | 32 | ||||
tb-fan speed | PWM | 33 | 34 | GND | |
35 | 36 | ||||
37 | 38 | ||||
GND | 39 | 40 |
User Guide
📄️ Raspberry Pi 5 Use Penta HAT
The Raspberry Pi 5 has a PCIe port that works well with the Radxa Penta SATA HAT.
📄️ Penta SATA HAT top board
The Radxa Penta SATA HAT has a 2x5 seat with the following signal:
📄️ Create RAID Arrays with mdadm
mdadm is a Linux software RAID tool that can be used to create, manage, and monitor software RAID arrays. In this guide, we will show you how to create RAID 0, RAID 1, RAID 5 and RAID 10 arrays using mdadm.