Skip to main content

Install OS to MicroSD Card

File download​

Please download the system image refer to Summary of resource downloads.

MicroSD card preparation​

Insert the MicroSD card into the SD card reader, and then insert the card reader into the USB port of the PC.

Image burning​

Balena Etcher is a cross-platform and user friendly image file burning tool that we recommend you use.

  1. Download Etcher and install it.

Please download balenaEtcher-Setup-1.18.11.exe After the download is complete, there is no need to perform any additional actions. After downloading, you can double click it to open it without any additional operation.

  1. Open Etcher

  2. Open Etcher and click Flash from file to select the image to write to.

  3. Click Select target to select the device, please select carefully.

  4. Click Flash! Start writing and wait for the write progress bar to complete.

  5. When writing the image successfully, Etcher will display Flash Complete!.

If there is an error in flashing, please try again.

Boot the system​

After successfully burning the MicroSD Card according to the above steps, insert the MicroSD Card into the MicroSD Card slot (as shown in the following figure), and then power on the system, the system will start booting up and HDMI will display the desktop.

sd slot

Log in to the System​

After the system boots, log in with the radxa account with the password radxa.

tip

The system boots from power on, the entire process lasts about 40 seconds, and then enters the system desktop.