Skip to main content

Install the system to the EMMC Module

File Download​

EMMC Module preparation​

Insert EMMC Module into EMMC Reader, and then insert the reader into the USB port of your PC.

Image burning​

Balena Etcher is a cross-platform and user friendly image file burning tool that we recommend you use.

  1. Download Etcher and install it.

Please download balenaEtcher-Setup-1.18.11.exe After the download is complete, there is no need to perform any additional actions. After downloading, you can double click it to open it without any additional operation.

  1. Open Etcher

  2. Open Etcher and click Flash from file to select the image to write to.

  3. Click Select target to select the device, please select carefully.

  4. Click Flash! Start writing and wait for the write progress bar to complete.

  5. When writing the image successfully, Etcher will display Flash Complete!.

If there is an error in flashing, please try again.

Boot the system​

After successfully burning the EMMC Module according to the above steps, insert the EMMC Module into the EMMC Module slot (as shown in the picture below), then power on the system, the system will start booting and HDMI will display the desktop.

emmc slot

Logging in to the system​

After the system boots up, log in using the radxa account with the password radxa.

tip

The whole process lasts about 40 seconds from powering on the system to booting it up, and then entering the system desktop.