Preparation
Required Cables
Radxa ROCK Pi S0 must be configured with a specialized cable in order to be used.
Wire Signal Definition
USB OTG / HOST Signal Definition
| color | signal |
|---|---|
| red | 5V |
| white | USB_DM |
| green | USB_DP |
| black | GND |
100Mbps Ethernet Signal Definition
| color | signal |
|---|---|
| red | RXN |
| green | RXP |
| white | TXN |
| black | TXP |
USB OTG Cable
The Radxa 4P to USB-A Male Cable is a 4-Pin MX1.25mm to Male USB cable that can be connected to a 5V adapter to power the ROCK Pi S0 or directly to a host computer for communication.
USB HOST Cable
The Radxa 4P to USB-A Female Cable is a 4-Pin MX1.25mm to female USB cable that provides the ROCK Pi S0 with an interface to USB devices.
100Mbps Ethernet Cable
The Radxa 4P to Ethernet Adapter Cable is a 4-Pin MX1.25mm to Ethernet adapter cable that provides access to a 100Mbps Ethernet network for the ROCK Pi S0.
Development preparation
Power supply
The Radxa ROCK Pi S0's power supply connector is a 4-Pin USB2.0 OTG connector, which can be used with USB OTG Cable, supports 5V input only.
Boot Media
microSD card, capacity not less than 8GB, for system boot disk
microSD card reader
Used to create system boot disk
Network connection
The ROCK Pi S0 has an on-board Wi-Fi module. The network can be accessed via Wi-Fi and a 4-Pin 100Mbps Ethernet connector.The 4-Pin 100Mbps Ethernet connector requires an 100Mbps Ethernet Cable.
Serial Debugging
Please refer to Serial Debugging Documentation.
Antenna Switch
Please refer to Antenna Switch Documentation