Skip to main content

FAQ

1. Can Radxa CM5 be used on Radxa CM3 IO board​

No, as the 3 pins (94/96/98) (USB_5V_IN) of the current CM3 + Radxa CM3 IO board are connected to 5V, while CM5 is GPIO. cm3 vs cm5

2. Can we replace Radxa CM3 with Radxa CM5 for hardware upgrade on the baseboard we previously developed based on Radxa CM3?​

  1. Please confirm whether the 3 pins (94/96/98) (USB_5V_IN) of the current CM3 + baseboard hardware design are connected to 5V. If so, then cannot replace with CM5, otherwise the board will be damaged

cm3 vs cm5

  1. If the 3 pins mentioned in step 1 above are not connected to 5V, then replace CM3 with CM5. After replacement, the following functional changes will occur.
    • Not support SPI Flash
    • There is a difference in SD card detection pin: CM3 is pin 76 on the first connector, while CM5 is pin 74 on the third connector. If you want to be compatible with Raspberry PI's CM4 IO board (SD card boot), IO board's third connector's pin 90 needs to be grounded.
    • Not support HDMI TX ARC function: Because CM3's second connector pin 145/149 is not connected to SBDP/SBDN signal
    • MIPI_CSI: Not support 4lane+2lane, only support 2lane+2lane
    • MIPI_DSI0: Not support 4lane+4lane, only support 4lane+2lane
    • Not support 3.5mm headphone audio, external CODEC is needed
    • Not support EDP: 15/17/21/23/27/29/33/35 pin, CM3 supports EDP, while CM5 is TYPE C
    • USB2_HOST3 not supported: 69/71 PIN CM3 is USB, while CM5 is I2C

3. Can CM5 directly replace CM3J on an existing carrier board?​

Do not treat CM5 as a pin-for-pin replacement for CM3J. Even where the connectors have the same placement, some connector pins have different functions. Before replacing the module, compare the carrier schematic against the CM3J V1.2 pinout and CM5 V2.21 pinout, checking power and every interface used by the carrier. Do not power on the assembly until these checks are complete. The CM3 carrier replacement guidance above does not apply to CM3J.

    You need to be logged into GitHub to post a comment. If you are already logged in, please ignore this message.

    Radxa-docs © 2026 by Radxa Computer (Shenzhen) Co.,Ltd. is licensed under CC BY 4.0