Skip to main content

Preparation

Required Cables

** Radxa ROCK S0 must be configured with a specialized cable in order to be used. **

Wire Signal Definition

USB OTG / HOST Signal Definition

colorsignal
red5V
whiteUSB_DM
greenUSB_DP
blackGND

100Mbps Ethernet Signal Definition

colorsignal
redRXN
greenRXP
whiteTXN
blackTXP

rocks0 sequence

USB OTG Cable

The Radxa 4P to USB-A Male Cable is a 4-Pin MX1.25mm to Male USB cable that can be connected to a 5V adapter to power the ROCK S0 or directly to a host computer for communication.

rocks0 otg

USB HOST Cable

The Radxa 4P to USB-A Female Cable is a 4-Pin MX1.25mm to female USB cable that provides the ROCK S0 with an interface to USB devices.

rocks0 usb

100Mbps Ethernet Cable

The Radxa 4P to Ethernet Adapter Cable is a 4-Pin MX1.25mm to Ethernet adapter cable that provides access to a 100Mbps Ethernet network for the ROCK S0.

rocks0 eth

Development preparation

Power supply

The Radxa ROCK S0's power supply connector is a 4-Pin USB2.0 OTG connector, which can be used with USB OTG Cable, supports 5V input only.

Boot Media

microSD card, capacity not less than 8GB, for system boot disk

microSD card reader

Used to create system boot disk

Network connection

The ROCK S0 has an on-board Wi-Fi module. The network can be accessed via Wi-Fi and a 4-Pin 100Mbps Ethernet connector.The 4-Pin 100Mbps Ethernet connector requires an 100Mbps Ethernet Cable.

Serial Debugging

Please refer to Serial Debugging Documentation.

Antenna Switch

Please refer to Antenna Switch Documentation

FAQ

Notes

Accessories