Skip to main content

eDP Interface

Accessory usage

Sharp LQ133T1JW01 Display

  • Connection

    Connect Radxa CM3 IO Board through the FPC cable as shown:

    display connection
  • Enable Overlay

    1. Open the Kconsole terminal via the Application Launcher in the lower left corner and run the rsetup command:
     radxa@radxa-cm3-io:~$ rsetup 
    1. Enable Overlay by Device Tree Configuration .
    tip

    Please enable [] Enable Sharp LQ133T1JW01 Display Overlay。
    Exit and reboot after enabling the successful display of [*] Enable Sharp LQ133T1JW01 Display for the configuration to take effect.

    1. Reboot
  • Test

    After reboot, Sharp LQ133T1JW01 Display is able to display the system screen and supports touch.