Skip to main content

Install the system on the EMMC Module

File download​

Please go to download to download system and loader file.

eMMC Module Preparation​

Insert eMMC Module into eMMC Reader, and then Insert Reader into PC's USB Port

tip

For on-board eMMC, please refer to USB Flashing section

Flash the image​

Balena Etcher is a cross-platform and user friendly image file burning tool that we recommend you use.

  1. Download Etcher and install it.

Please download balenaEtcher-Setup-1.18.11.exe After the download is complete, there is no need to perform any additional actions. After downloading, you can double click it to open it without any additional operation.

  1. Open Etcher

  2. Open Etcher and click Flash from file to select the image to write to.

  3. Click Select target to select the device, please select carefully.

  4. Click Flash! Start writing and wait for the write progress bar to complete.

  5. When writing the image successfully, Etcher will display Flash Complete!.

If there is an error in flashing, please try again.

Boot System​

After successfully flashing the eMMC Module using the previous steps, insert the eMMC Module into the eMMC Module slot (as shown in the image below). Then, power on the device. The power indicator light will display a solid green color, indicating the system has started booting up. Once the normal startup process completes, the indicator light will begin blinking. After a short period of time, the HDMI output will display the desktop.

eMMC slot

Login System​

After the system boots up, log in using the radxa account with the password radxa.

tip

The entire process lasts about 40 seconds from powering on the system to booting it up and then to the system desktop.